Beyond Bending Tell You How
Are you planning to replace your old dishwasher with a new one? Or perhaps you’re moving to a new home and need to remove and install your dishwasher? Whatever your reason may be, the process of dishwasher removal and installation can be a bit daunting. But don’t worry, we’ve got you covered. In this article, we’ll guide you through the whole process step by step.
Before You Start
Before you begin the removal and installation process, there are a few things you need to prepare. First, make sure you have all the necessary tools, including a screwdriver, pliers, and a wrench. Second, turn off the power and water supply to your dishwasher. You can usually find the power switch under the sink or in the circuit breaker box. As for the water supply, turn off the valve that’s connected to the dishwasher’s water line.
Removing the Old Dishwasher
Now that you’ve prepared everything, it’s time to remove the old dishwasher. Here’s how:
Step 1: Disconnect the power and water supply
Using your screwdriver, remove the cover plate at the bottom of the dishwasher. This will give you access to the power cord and water supply line. Disconnect both of them using your pliers.
Step 2: Remove the dishwasher from its place
Most dishwashers are held in place by screws or brackets. Use your wrench or screwdriver to remove them. Once the dishwasher is loose, carefully pull it out from its place. Be careful not to damage the flooring or the surrounding cabinets.
Step 3: Disconnect the drain hose
The drain hose is usually connected to the garbage disposal or the sink drain. Use your pliers to loosen the clamp that’s holding the hose in place. Once the clamp is loose, pull the hose out of the drain.
Step 4: Prepare the old dishwasher for disposal
Before you dispose of the old dishwasher, make sure you remove any remaining water from the unit. You can do this by using a sponge or a towel to soak up the water from the bottom of the dishwasher. You should also detach any racks or accessories and clean them separately.
Installing the New Dishwasher
Now that the old dishwasher is out of the way, it’s time to install the new one. Here are the steps:
Step 1: Prepare the new dishwasher
Before you install the new dishwasher, make sure you remove all the packaging materials and accessories. You should also remove the cover plate at the bottom of the unit and attach the power cord and water supply line. Make sure you connect the water supply line to the hot water valve.
Step 2: Slide the new dishwasher into place
Slide the new dishwasher into the space where the old dishwasher used to be. Make sure it’s level and flush with the surrounding cabinets. You should also check that the water supply line and drain hose are not kinked or twisted.
Step 3: Connect the drain hose
Attach the drain hose to the garbage disposal or sink drain. Make sure you tighten the clamp securely so that there are no leaks.
Step 4: Secure the dishwasher in place
Use screws or brackets to secure the dishwasher in place. Make sure it’s firmly anchored to the surrounding cabinets or countertop.
Step 5: Connect the power and water supply
Finally, connect the power and water supply to the new dishwasher. Turn on the water supply valve and the circuit breaker, and test the dishwasher to make sure it’s working properly.
Conclusion
Removing and installing a dishwasher may seem like a daunting task, but with the right tools and knowledge, it’s actually quite simple. Just remember to turn off the power and water supply, follow the steps we’ve outlined in this article, and take your time. Before you know it, you’ll have a brand new dishwasher up and running in your kitchen.
