Beyond Bending Tell You How
Introduction
Dishwashers are an essential part of our daily lives. They save time and effort, and make cleaning up after meals much easier. However, like any other appliance, dishwashers can develop faults over time. One common problem is a faulty pump, which can cause the dishwasher to stop working altogether. In this article, we will guide you through the process of replacing the pump on your Whirlpool dishwasher.
Step 1: Safety First
Before you begin any work on your dishwasher, make sure you turn off the power supply to the appliance. You can do this by unplugging it from the wall, or by turning off the circuit breaker that supplies power to the dishwasher.
Step 2: Remove the Lower Dishrack
To access the pump, you will need to remove the lower dishrack from the dishwasher. Simply slide it out of the appliance and set it aside.
Step 3: Remove the Lower Spray Arm
The lower spray arm is held in place by a retaining nut. Use a pair of pliers to loosen the nut and remove the spray arm.
Step 4: Remove the Filter Assembly
The filter assembly is located under the lower spray arm. It can be removed by rotating it counterclockwise and pulling it out.
Step 5: Disconnect the Pump
The pump is connected to the dishwasher by two wires and a hose. Disconnect these by gently pulling them away from the pump.
Step 6: Remove the Pump
The pump is held in place by a mounting bracket. Loosen the screws on the bracket and remove it from the dishwasher. You should now be able to remove the pump from the appliance.
Step 7: Install the New Pump
Take your new pump and install it in the same position as the old one. Use the mounting bracket to secure it in place.
Step 8: Reconnect the Wires and Hose
Reconnect the wires and hose to the new pump. Make sure they are securely in place.
Step 9: Reinstall the Filter Assembly
Put the filter assembly back into the dishwasher and rotate it clockwise to secure it in place.
Step 10: Reinstall the Lower Spray Arm
Put the lower spray arm back in place and tighten the retaining nut with your pliers.
Step 11: Reinstall the Lower Dishrack
Slide the lower dishrack back into the dishwasher.
Step 12: Restore Power
Turn the power supply back on to the dishwasher.
Step 13: Run a Test Cycle
Run a test cycle to make sure the dishwasher is functioning properly. If everything is working as it should, you’re good to go!
Conclusion
Replacing the pump on your Whirlpool dishwasher may seem like a daunting task, but with the right guidance, it can be a simple and straightforward process. By following these steps, you can get your dishwasher back up and running in no time.
