Beyond Bending Tell You How
Full overlay cabinets are a popular choice for modern kitchens due to their sleek, seamless appearance. However, they can pose a challenge when it comes to installing crown molding. In this article, we will guide you through the process of installing crown molding on full overlay cabinets.
Materials Needed
Before you begin, gather the following materials:
- Crown molding
- Measuring tape
- Miter saw
- Nail gun
- Wood glue
- Sandpaper
- Paint or stain (optional)
Step 1: Measure
Measure the length of the cabinet runs where you will be installing the crown molding. You will need to take into account any corners or angles in the cabinets. Add 10% to your total length to allow for waste.
Step 2: Cut
Using a miter saw, cut the crown molding to the correct lengths and angles. It is important to make precise cuts to ensure a tight fit. Sand any rough edges or corners.
Step 3: Install
Apply wood glue to the back of the crown molding and press it firmly into place on the top of the cabinet, ensuring it is flush with the cabinet face. Use a nail gun to secure the crown molding in place.
Step 4: Repeat
Repeat steps 2 and 3 for each section of the cabinet where you will be installing crown molding.
Step 5: Fill and Sand
Fill any nail holes or gaps in the crown molding with wood filler. Once the filler is dry, sand the entire surface of the crown molding until it is smooth and even.
Step 6: Paint or Stain (Optional)
If desired, you can paint or stain the crown molding to match the cabinets or add a contrasting color. Allow the paint or stain to dry completely before moving on.
Step 7: Enjoy!
Admire your newly installed crown molding on your full overlay cabinets. It adds a touch of elegance and sophistication to your kitchen.
Tips and Tricks
- Consider using a coping saw instead of a miter saw for the corners to ensure a perfect fit.
- Take your time and measure twice to avoid costly mistakes.
- Use a nail gun with small nails to avoid splitting the crown molding.
- For a more seamless look, consider using a piece of trim to cover the joint where two pieces of crown molding meet.
